Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
In life, we always produce fumes when cooking. Then the problem comes. The Range Hood we use every day must be covered with dirt that is difficult to clean. It is not only greasy, but also disgusting. Many times we just enjoy it in the process of using it, and when it comes to cleaning up, everyone wants to ignore it. If you want to clean but you can't start, how to remove and wash the range hood? Next, decorate the home decoration network Xiaobian to take everyone to look at the range hood cleaning and washing related content.
How to remove and wash the range hood
1, boil water
If there is a period of time that is not cleaned, we will find that there is a lot of oil on the oil net, they will drip into the lower oil storage box, so if you want to clean the oil net, you must first let the oil on the oil drop quickly into the oil storage box. It is very simple. Prepare a pot under the hood and boil water.
2, wait ten minutes
After the water is opened, let it boil. Turn on the hood and absorb the water vapor. So for about ten minutes, you can find that the oil on the oil net will flow along the oil net to the oil storage box. Of course, it is only part of it. It will also be convenient.
3, remove the oil network
At this time, the oil-filled box and the oil net are quickly removed, and the screws can be loosened. It is extremely simple, but it is necessary to remind everyone that the internal electrical connection and air-tight sealing parts of the hood should not be frequently removed and washed, and the sealing ring is often removed. It is easy to cause aging deformation, oil and easy to enter, then it will naturally affect its safety and reduce the service life of the hood.
4, oil net soak
Prepare a basin of hot water, add some detergent, and then soak the oil in it, usually for 15 minutes. In fact, you can use alkali, vinegar or strong degreaser instead. Of course, if you have the conditions, it is recommended to use strong degreaser. It is specially designed to remove oil and decontamination is more thorough.
5, cleaning oil net
After the time of the dipping oil is about the same time, scrub with a cleaning cloth. If there is residual oil, add some degreaser, or use a steel ball or brush to clean until it is washed.
6, scrubbing detergent
After washing, dry the surface, and then apply a layer of cleaning agent again, as if it is coated with a protective film for the next cleaning, but the cleaning interval should not be too long, otherwise the oil smoke will accumulate too thick. Dishwashing detergent will also lose its effectiveness.
7, put back the hood
After all the parts have been scrubbed, then the installation is left, and finally remember to open the trial, normal.
The above content is a wonderful introduction to the contents of the range hood cleaning and washing. I hope that every reader can listen to it and apply it in real life. You will benefit a lot. Well, today's introduction to the range hood cleaning and washing content is here. Thanks to the readers for reading this article and for the support and love of Xiaobian. If you want to get more home decoration information, please continue to pay attention to the decoration. Home network.
More related wonderful reading:
Range hood cleaning method range hood cleaning coup
induction cooker coil,induction cooker spare parts,induction cooker ceramic glass,induction cooker pcb board,induction cooker motherboard
March 16, 2022
March 18, 2020
September 27, 2024
September 27, 2024
1. The applicable range of waterproof tape is suitable for high quality roll-type marine sealing tapes under normal weather conditions. 2. Roofing waterproofing, underground waterproofing,...
There are three types of range hoods in the market: thin, deep and cabinet. When purchasing, you should first determine the type of purchase based on your kitchen's specific pattern and personal...
The buried lights are square and round in shape, and are widely used in shopping malls, parking lots, green belts, park brigades, tourist attractions, residential quarters, urban sculptures,...
Huake refractory XZ-L690 is used for making cement, porcelain, paint filler, mordant, metal aluminum and so on. It can be added to various water-based resins, oil-based resins, epoxy resins, acrylic...
Email to this supplier
March 16, 2022
March 18, 2020
September 27, 2024
September 27, 2024
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.